Build Guide - Calibration
  1. Connect 0.0VDC to [CV IN]
  2. Connect a 1Hz 5VDC squarewave to [CLOCK]
  3. Wait for about 5 seconds
  4. Monitor U201_6 and adjust P201 for a reading of 0.0V
  5. Repeat for U202_6/P202, U203_6/P203 and U204_6/P204
  6. Connect 5.0VDC to [CV IN]
  7. Wait about 5 seconds
  8. Monitor [OUT 1] and adjust P205 for 5.0VDC
  9. Repeat for [OUT 2]/P206 & [OUT 3]/P207.
Email:  elby-designs@bigpond.com
© Copyright 2000. All rights reserved.     Revised: September 13, 2023