The CG407 is a single-channel oscilloscope ideal for monitoring signals in your system.
| Parameter |
Value |
| Real-time sampling rate |
1MSPS (max) |
| Sensitivity |
1V/div - 5V/div in "1-2-5" steps |
| Timebase |
10uS/div - 500uS/div in "1-2-5" steps |
| Capture buffer size |
1024 bytes |
| Trigger modes |
Automatic/Normal/Single |
| Display size |
2.4" (61mm) |
| Display resolution |
320 pixels x 240 pixels |
| Input impedance |
1M ohm/20pF |
| ADC resolution |
12-bits |
The DataLogger section at the top of the screen displays:-
- Vpp - Shows the difference between the extreme Maximum and Minimum values
- Vavr - The Average reading is the mean vertical level of the entire captured waveform
- Freq - The Frequency is the inverse of the Period and is measured in Hertz
Pressing the [SELECT] button steps the user through the various control settings displayed around the edge of the screen, the currently active setting being highlighted within a blue frame. At each setting, pressing the [-] and [+] buttons will step through the available options.
Pressing the [HOLD/OK] button will freeze the current display allowing for closer inspection of the input signal.
Pressing the [HOLD/OK] button while in the lower left corner of the screen, the user can toggle the [AUTO SIZE] ([A.S]) function on and off. When enabled, [A.S] will automatically resize the input signal to fill the scope display area. This is useful when you have a signal on the display which doesn't optimally fit in any of the [VOLTS/DIV] settings. The DataLogger still displays the correct data for the input signal.
.
