3D Model	Overlay	Plan View
Column 1 PCB
Column 2 PCB
Back PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Assemble the 2x Jack Carrier boards
2. Assemble the Switch Carrier board
3. Fit the LED lens to the front panel
4. Fit all components to their respective PCBs except for the sub-assemblies and LED
5. Mount the sub-assemblies on to the Column 1 PCB but do not solder
6. Offer the Column 1 assembly up to the front panel and secure using the supplied nuts and washers
7. Solder the sub-assemblies in to position
8. Some builders may wish to temporarily remove the Column 1 assembly to allow easier access to soldering the LED in the next steps
9. Mount the LED on to the Column 2 assembly but do not solder
10. Offer the Column 2 assembly up to the front panel and secure using the supplied nuts
11. Position the LED in to its lens mount and then solder in to place
12. Mount the Back PCB assembly ensuring that the IDC connectors are correctly aligned