3D Model	Overlay	Plan View
ES21 Support PCB
ES06 Column 2 PCB
Panther Jack-LED PCB
ES06 PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Fit all components to the Support Boards except for the 2 LEDs, J301E and J301G in Column 3
2. Mount the Column 3 assembly on to the front panel and secure using the supplied nutsl
3. Install and solder the 2 LEDs
4. Mount the 2 remaining PCB assemblies to the front panel and secure using the supplied nuts and washers
5. Fit all components to the Main Board
6. Mount the Main Board on to the front panel assembly ensuring that the IDC sockets are correctly aligned
   

Addendum

R402 has been replaced by a zener diode. See 3D Model for correct orientation