3D Model	Overlay	Plan View
Column 1 PCB
Column 2 PCB
ES07 PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Assemble the 5x Jack Carrier Board assemblies (3D Model)
2. Assemble the 1x Switch Carrier Board assembly (3D Model)
3. Fit all components to the boards following normal assembly guidelines except for the sub-assemblies
4. Place the 2x jack sub-assemblies on the Column 1 PCB but do not solder
5. Offer the assembly up to the panel securing using the supplied nuts
6. Solder the sub-assemblies in to position
7. Place the 3x jack sub-assemblies and 1x switch sub-assembly on to the Column 2 PCB but do not solder
8. Offer the assembly up to the panel and secure using the supplied nuts
9. Solder the sub-assemblies in to place
10. Fit the Main Board to ensure correct alignment of the Column 2 PCB and secure the assembly using the supplied nuts