3D Model	Overlay	Plan View
Column 1 PCB
Column 2 PCB
Column 3 PCB
Backboard PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Assemble the Switch Carrier board
2. Fit all components to the boards except for the Switch Carrier sub-assembly and LED
3. Assemble the 3 support boards first
4. Mount the Switch Carrier sub-assembly on to the Column 2 PCB but do not solder
5. Offer the assembly up to the panel and secure using the supplied nuts
6. Check the switch toggle is orientated vertically and solder in to place
7. Remove the Column 2 assembly and insert the Column 3 board
8. Carefully form the LED legs, insert and solder in to place
9. Install the Column 2 assembly
10. Install the Column 1 assembly
11. Mount the backboard on to the column boards ensuring that the IDC connectors are properly aligned.