3D Model	Overlay	Plan View
PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Mount J102 and J201 on to their Carrier Boards
2. Prepare the LED by extending it's legs using the supplied wire (refer to General Construction Notes)
3. Fit all components to the main PCB except for the jack sub-assemblies and the LED. Note that R302 has been replaced by a diode which should be orientated as shown in the overlay
4. Mount the jack sub-assemblies on to the main PCB aassembly but do not solder
5. Offer the assembly up to the front panel and secure using the supplied nuts and washers
6. Solder the sub-assemblies in to place
7. Install the LED and solder in to place