The miniMIDI-WASP Interface Unit lets you control your WASP, GNAT or any other EDP LINK compatible device from any suitable MIDI controller such as a PC, MIDI Keyboard or MIDI Sequencer.

A LEARN button allows the miniMIDI-WASP to be assigned to a MIDI channel and to also define the lowest C note value, on receipt of the next MIDI NOTE-ON message.

On the latest PCB revision the LEARN switch is also provided as onboard switch for situations where the LEARN mode will be a set-and-forget option and so does not require regular or easy access.

To restore factory default settings, press and hold the LEARN switch, at power on, for about 2 seconds.

This unit is also available fully assembled and tested.

The miniMIDI-WASP board will fit neatly in to the space at the rear of the WASP as can be seen in the picture below.

Power for the miniMIDI-WASP is, typically, derived from the host units supply.