3D Model	Overlay	Plan View
PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Install the LENS Mount on to the front panel
2. Assemble the 3x Jack Carrier Board assemblies J101, J103 & J301
3. Fit all components to the main PCB except for the 3x sub-assemblies
4. Mount the sub-assemblies to the main PCB assembly but do not solder
5. Offer the assembly up to the front panel and secure using the supplied nuts and washers
6. Solder the sub-assemblies in to place