Set [ATTENUATION] fully clockwise to ‘0dB’

CV Feedthrough Adjust

CHANNEL 1

1. Set [GAIN][1] fully clockwise
2. Connect a 50Hz 5VDC sawtooth to [PAN CV][1]
3. Set [PAN][1] to 'L'
4. Set [PAN CV][1] to 'L-R'
5. Monitor TP5
6. Adjust P101 for minimum break-through
7. Set [PAN] [1]to 'R'
8. Set [PAN CV][1] to 'R-L'
9. Monitor TP6
10. Adjust P102 for minimum break-through

CHANNEL 2

1. Set [GAIN][2] fully clockwise
2. Connect a 50Hz 5VDC sawtooth to [PAN CV][2]
3. Set [PAN][2] to 'L'
4. Set [PAN CV][2] to 'L-R'
5. Monitor TP5
6. Adjust P201 for minimum break-through
7. Set [PAN][2] to 'R'
8. Set [PAN CV][2] to 'R-L'
9. Monitor TP6
10. Adjust P202 for minimum break-through

GAIN ADJUST

CHANNEL 1

1. Set [GAIN][1] fully clockwise
2. Connect a 1kHz 5VAC triangle to [CHANNEL 1]
3. Set [PAN][1] to 'R'
4. Monitor TP5
5. Adjust P103[1] for an output of 5.5VAC p-p
6. Set [PAN][1] to 'L'
7. Monitor TP6
8. Adjust P104[1] for an output of 5.5VAC p-p

CHANNEL 2

1. Set [GAIN][2] fully clockwise
2. Connect a 1kHz 5VAC triangle to [CHANNEL 2]
3. Set [PAN][2] to 'R'
4. Monitor TP5
5. Adjust P103[2] for an output of 5.5VAC p-p
6. Set [PAN][2] to 'L’
7. Monitor TP6
8. Adjust P104[2] for an output of 5.5VAC p-p