3D Model	Overlay	Plan View
PCB

Constructors should refer to the Component Overlays along with,
the Bill of Materials for the current value of all components, and
the General Construction Notes for general PCB assembly guidelines.

1. Fit the LED lens mount to the front panel
2. Assemble the Panther Carrier Jack PCBs
3. Assemble the Panther Support PCB for Column 1 but do not fit the Jack assemblies
4. Mount the Jack assemblies on to the Column 1 PCB but do not solder
5. Off the assembly up to the front panel and secure using the supplied nuts and washers
6. Solder the Jack assemblies into place
7. Remove the PCB assembly from the front panel
8. Assemble the ASM320 PCB but do not fit the LED
9. Mount the LED but do not solder
10. Offer the assembly up to the front panel and secure using the supplied nuts
11. Form the LED and insert in to it sposition on the ASM320 PCB, taking careful note of its orientation
12. Solder the LED in to place
13. Refit the Column 1 assembly
14. Fit the IDC cable between the 2 PCB assemblies folding the cable between the 2 PCBs to minimse stress on the assembly
15. Fit the IDC power cable .